I split my Boba Fett helmet STL in Slic3r. It was incredibly easy to split the file into 8 parts. The top and bottom halves split at the visor line, then split those pieces into halves and then halves again so they will fit on the bed. Source: almost 2 years ago
Try using a diffent slicer. Either cura or slic3r. Source: over 2 years ago
I use Slic3r where the preview is quite easy to get, but the configuration might be a bit scary to get done (although the defaults are reasonable) as you want to try with adding or removing support material. Source: almost 3 years ago
Do you know an article comparing Slic3r to other products?
Suggest a link to a post with product alternatives.
This is an informative page about Slic3r. You can review and discuss the product here. The primary details have not been verified within the last quarter, and they might be outdated. If you think we are missing something, please use the means on this page to comment or suggest changes. All reviews and comments are highly encouranged and appreciated as they help everyone in the community to make an informed choice. Please always be kind and objective when evaluating a product and sharing your opinion.