jscut VS Ink/Stitch

So I made a mini plotter based on this tutorial, and while the g-codes the site uses as examples are working fine, when I try to upload my own g-codes, they fail. More specifically, they either try to make an image way bigger than the range of the machine, and they aren't lowering the pen correctly. I've been using jscut.org to convert svg files to gcode, and I think it's probably because the site is suboptimal... Source: over 2 years ago

Also embroidery machines and fabric cutting machines: https://inkstitch.org/. - Source: Hacker News / 6 months ago

Go to their official website and follow their install instructions. Source: about 1 year ago

If you are trying to make your own, from a picture or something there are some commercial options or you can use Inkspace with the plug-in called https://inkstitch.org/. If you do Cricut, then the same line drawing transformation ideas apply to make your own patterns. Source: about 1 year ago

No tutorials, I just read the docs at inkstitch.org, they did a good job and guiding initiates along with that alone. I do have a few things to add: 1. Make sure your paths don't have node breaks you can't immediately see. During a Params visualization, a few satin stitch columns stopped short, but looked complete on the artboard. After 3 hours of trolling around for a similar predicament solved and no luck, I... Source: over 1 year ago

Look at the free Inkscape design software with the free InkStitch plug-in, and the tutorials on using them in the LowTechLinux youtube channel. Source: over 1 year ago