Polar Cloud VS Slic3r

Do you need to access your printer over the internet? Possibly not. But your position is that BL are sending data to their cloud service without good reason. That it offers a feature not provided by Octoprint and Mainsail is that good reason. There are even 3rd party services for Octoprint to ADD this functionality and they charge money for it e.g. https://polar3d.com/. Source: about 1 year ago

Polar Cloud is hosted in the west and in my opinion integrates better with the printer than Flashcloud. Source: over 2 years ago

Have 3 flashforge guider IIs that connect to polar cloud, https://polar3d.com/. Don’t know if this is a flashforge program or 3rd party. There is a setting to allow for polar cloud connect. Source: over 2 years ago

I split my Boba Fett helmet STL in Slic3r. It was incredibly easy to split the file into 8 parts. The top and bottom halves split at the visor line, then split those pieces into halves and then halves again so they will fit on the bed. Source: almost 2 years ago

Try using a diffent slicer. Either cura or slic3r. Source: over 2 years ago

I use Slic3r where the preview is quite easy to get, but the configuration might be a bit scary to get done (although the defaults are reasonable) as you want to try with adding or removing support material. Source: almost 3 years ago