SSD Fan Control VS Stats

5) your fans may run on high after replacement of the drive because the lack Apple specific temp sensors. You can get a utility called ssd fan control set it to smart control and to start up with the system. You won’t have to worry about loud fans after that. Source: over 1 year ago

Keep in mind that when you swap the HDD on these iMacs, you'll lose the thermal control on the hard disk. Download this app and run it using the default settings. This will prevent your iMac from sounding like a jet engine and run the fan speeds to default. Source: over 2 years ago

You may also find that the fans spin up loud and persistently if all you do is a straight swap. The app "SSD Fan Control" will sort this out for you. https://exirion.net/ssdfanctrl/. Source: about 3 years ago

It's possible to switch between two fan modes with "SSD fan controll" in macOS. Not sure if it'll work with FakeSMC, I'm on VirtualSMC. But I can't turn off EC. The only thing it does is that it writes fan values faster than the EC. Source: about 3 years ago

Its not a terminal app like bottom or nvtop but I use https://github.com/exelban/stats and it has iGPU stats. - Source: Hacker News / about 2 months ago

I’ve found stats [1] to be a great open source alternative to the iStat Menus system monitor app mentioned in the article. [1] https://github.com/exelban/stats. - Source: Hacker News / 4 months ago

Have not used it for quite some time, and I think it was launching the Mac system monitor , it does don't have its own widow , but you can check this https://github.com/exelban/stats. Source: 10 months ago

Install stats and put it in your menu bar. It will show the top processes. If my battery is going down quicker than usual I check there and it is usually some hungry tab in Firefox. But I've also noticed bluetoothd using way more CPU than I would expect. Source: 10 months ago

Don't know about 'better looking', but I use https://github.com/exelban/stats. Source: 11 months ago