SmoothieControl VS Slic3r

Create an account or sign in to GitLab here. - Source: dev.to / 7 months ago

Would you be able to send me a rayID of a failed challenge so I can take a loop? It sounds like you can use https://gitlab.com/users/sign_in to generate one. You can either reply in the comments with the ID (no PII), or email me at amartinetti at cloudflare.com and I'd love to dig into it. We're building Turnstile because we want to make challenges a better system than CAPTCHA. It sounds like for you it's worse,... - Source: Hacker News / 9 months ago

I've had the exact same problem for a while. Here are some of the sites I've been unable to access (found by searching for "just a moment" in my browser history): * https://gitlab.com/users/sign_in. - Source: Hacker News / 9 months ago

Oh interesting , so https://gitlab.com/users/sign_in loads fine with the onboard ethernet? Source: about 1 year ago

One site that would never load with it was https://gitlab.com/users/sign_in. Source: about 1 year ago

I split my Boba Fett helmet STL in Slic3r. It was incredibly easy to split the file into 8 parts. The top and bottom halves split at the visor line, then split those pieces into halves and then halves again so they will fit on the bed. Source: almost 2 years ago

Try using a diffent slicer. Either cura or slic3r. Source: over 2 years ago

I use Slic3r where the preview is quite easy to get, but the configuration might be a bit scary to get done (although the defaults are reasonable) as you want to try with adding or removing support material. Source: almost 3 years ago