CraftWare VS Slic3r

I dunno honestly This is a config file of the craftware slicer. I had a problem with it not picking up the settings and decided to find where they are. so, after that I decided I'll stick with cura instead. Source: over 2 years ago

CraftWare essentially functions as a slicer for essential 3d printer compatible software. However, it is additionally a brilliant device for some different errands. You can intelligently deal with your prints, decreasing form time and tracking down the ideal form upholds. Craftbot software additionally uses the most fantastic code visualizer available; this permits you to see each print layer-by-layer from any... Source: about 3 years ago

I split my Boba Fett helmet STL in Slic3r. It was incredibly easy to split the file into 8 parts. The top and bottom halves split at the visor line, then split those pieces into halves and then halves again so they will fit on the bed. Source: almost 2 years ago

Try using a diffent slicer. Either cura or slic3r. Source: over 2 years ago

I use Slic3r where the preview is quite easy to get, but the configuration might be a bit scary to get done (although the defaults are reasonable) as you want to try with adding or removing support material. Source: almost 3 years ago