CircuitLab VS EasyEDA

CircuitLab Reviews

EasyEDA Reviews

CircuitLab mentions (6)

• I'm looking for an engineer to help me design a very basic comparison circuit for 2 batteries that will light an led if a battery is low while the other battery powers the load. $100 offered

  I need someone to design and point me to the correct parts for a circuit that will use 2, 5V LiPo batteries that are rechargeable, in a circuit that is built to run a memory bank. Basically a CMOS circuit, very low current draw. I need the LED indication to replace a battery. The switching between them has to be fast enough that the memory doesn't lose the program on it. $100 to the first person with a full parts... Source: 11 months ago

• Is there a circuit simulation software? I'm very much a beginner.

  My go-to site for a quick simulation, and pretty schematics (that sounds almost NSFW) is circuitlab.com. Source: about 1 year ago

• How to design preamp pedals?

  If you have a 10 band EQ pedal into a flat amp you can hear what these frequency shapes sound like. Once you understand what these preamps are doing, then you can learn about the electronic side, read the schematics, and start designing / playing with your own circuit mods / designs. A circuit simulator (like circuitlab.com) would be a good place to start doing that. Source: over 1 year ago

• Is this circuit solving correct ?

  Tips if you want to check is circuitlab.com. Its very fast and easy to check. Source: about 2 years ago

• Need some help here...

  I used circuitlab.com to simulate this behaviour, to obtain this image, which show what happens to the voltage across a capacitor when it is charged by passing a constant current through it. Noite that the slope (gradient) of the plot is constant during the entire time current is passing. Source: almost 3 years ago

EasyEDA mentions (43)

• LibrePCB – Create electronics the easy way

  Https://easyeda.com/ is another alternative that has PCB factories backing it up. - Source: Hacker News / 7 months ago

• What is "this type" of PCB "called"

  a bunch of pcb manfacturing places have their own layout software which may or may not suite your needs. E.g. JLCPCB is a very good board manufacturer (and cheap to boot), and their EasyEDA software looks sane. Digikey has SnapEDA etc. Source: 11 months ago

• Can someone explain how this white LED works?

  It depends how good your electronics are or whether you're willing to invest time into learning PCB design. The capacitor's values can be found using an LCR meter, it will be a bit fiddly and you'll want to remove them from the flex PCB before testing. LCR meter can be picked up cheap on Amazon. Looks like a relatively simple circuit too, so you can trace it out quite easily. Then just measure up the PCB and you... Source: 11 months ago

• how to make/design your own custom Arduino for specific purposes

  There are lots of free tools out there, but I would suggest EasyEDA. Backed by JLCPCB, one of the best PCB makers in China, you could design your schematic and PCB and then have JLCPCB make the circuit boards for you. Everything is online and free, with lots of support. Source: 12 months ago

• double sided perfboard options

  For designing them there are various tools out there. Personally I find https://easyeda.com/ and https://upverter.com/ easier to get started with. Other popular option (but with a much steeper learning curve) are kcad, but I have always found that to be clunky UI. https://fritzing.org/ is another local option that is easy to use but last time I tried it would crash on me all the time making it basically unusable -... Source: 12 months ago