Slic3r VS OctoPrint

I split my Boba Fett helmet STL in Slic3r. It was incredibly easy to split the file into 8 parts. The top and bottom halves split at the visor line, then split those pieces into halves and then halves again so they will fit on the bed. Source: almost 2 years ago

Try using a diffent slicer. Either cura or slic3r. Source: over 2 years ago

I use Slic3r where the preview is quite easy to get, but the configuration might be a bit scary to get done (although the defaults are reasonable) as you want to try with adding or removing support material. Source: almost 3 years ago

The cheapest way is to use OctoPrint. Octoprint itself is free, and although it's often run on a Raspberry Pi, it can be installed on many things, such as an old laptop runing Linux or even Windows, or a small single-board computer. OctoPrint would connect to the printer using a USB cable, and you'd send the slicer output to Octoprint over your WiFi. Source: 4 months ago

2023-11-08 14:10:57,263 - octoprint.util.connectivity.connectivity_checker - INF O - Resolving octoprint.org is working. Source: 5 months ago

- Two LibreELEC (https://libreelec.tv/) mediaplayers in house (yes, one is not enough in my big family). - One for hosting low usage applications at home network (Unifi controller and some more). - Octoprint (https://octoprint.org) connected to the 3d-printer. - One on my desk for hardware hacking – mostly as just a PC with GPIO. - Some Raspberry Pi Zeros as security cameras. - Source: Hacker News / 7 months ago

Really quite easy, especially if you have ever dealt with a raspberry pi before. Once installed & set up, you manage everything over a web interface. I even added a webcam to it in order to see what's going on. Check out https://octoprint.org/. Source: 9 months ago

For other devices it can be harder, there are guides for installing on Linux on the octoprint website (I use an old laptop running Linux Mint). If using an old Android phone look for Octo4A. Source: 10 months ago